Motorola WiNG 5.5 Reference Manual page 291

Overrides
8. To edit (or override) the configuration of an existing port, select it from amongst those displayed and select the
The Ethernet Port Basic Configuration screen displays by default.
9. Set (or override) the following Ethernet port Properties and CDP/LLDP settings:
Description
Admin Status
Speed
Click the Clear to clear overrides made to this interface. This field is blank if there are no
overrides for this configuration.
Figure 5-128 Ethernet Ports - Basic Configuration screen
Provide a brief description for the access point's port (64 characters maximum).
Select the Enabled radio button to define this port as active to the profile it supports.
Select the Disabled radio button to disable this physical port in the profile. It can be
activated at any future time when needed.
Set the speed at which the port can receive and transmit the data. Select either 10 Mbps,
100 Mbps, 1000 Mbps. Select either of these options to establish a 10, 100 or 1000 Mbps
data transfer rate for the selected half duplex or full duplex transmission over the port.
These options are not available if Auto is selected. Select Automatic to enable the port
to automatically exchange information about data transmission speed and duplex
capabilities. Auto negotiation is helpful when in an environment where different devices
are connected and disconnected on a regular basis. Automatic is the default setting.
Device Configuration 5 - 205
Edit button.