Motorola WiNG 5.5 Reference Manual page 228

5 - 142 WiNG 5.5 Access Point System Reference Guide
6. Use the Offline Resource Detection
Options include Any and All. If selecting Any, an event is generated when the state of any single critical resource changes.
If selecting All, an event is generated when the state of all monitored critical resources change.
7. Select the IP
the same subnet) using the provided critical resource IP address as a network identifier.
8. Select the Interface
the critical resource's VLAN, WWAN1 or PPPoE1 interface. If VLAN is selected, a spinner control is enabled to define the
destination VLAN ID used as the interface for the critical resource.
9. Select + Add Row
IP Address
Mode
Port
VLAN
Figure 5-90 Critical Resources screen - Adding a Critical Resource
drop-down menu to define how critical resource event messages are generated.
option (within the Monitor Via
option (within the Monitor Via
to define the following for critical resource configurations:
Provide the IP address of the critical resource. This is the address used by the access point to ensure
the critical resource is available. Up to four addresses can be defined.
Set the ping mode used when the availability of a critical resource is validated. Select from:
• arp-only – Use the Address Resolution Protocol (ARP) for only pinging the critical resource. ARP
is used to resolve hardware addresses when only the network layer address is known.
• arp-and-ping – Use both ARP and Internet Control Message Protocol (ICMP) for pinging the critical
resource and sending control messages (device not reachable, requested service not available,
etc.).
Provide the port on which the critical resource is available. Use the spinner control to set the port
number.
Define the VLAN on which the critical resource is available using the spinner control.
field at the top of the screen) to monitor a critical resource directly (within
field at the top of the screen) to monitor a critical resource using either