Epson Artisan 810 Service Manual page 146

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Make sure to insert the decompression tube into the socket on
the Cartridge Box Unit to the full to its base. (See
Make sure to align the positioning hole (x1) on the Cartridge
Box Unit with the dowel (x1) of the Base Frame when
reassembling them. (See
When installing the Cartridge Box Unit, make sure to secure
the hooks (x2) on the Main Frame to their positioning holes
(x2). (See Fig. 4-82.)
Figure 4-82. Installing the Cartridge Box Unit
Make sure to attach the grounding plate to the place shown in
Fig. 4-80, and secure it with the screw.
DISASSEMBLY/ASSEMBLY
Fig. 4-73.)
Fig. 4-82.)
Positioning hole & dowel
Positioning hole & hook
Disassembly Procedures
Secure the convex sections (x2) of the Clamp Tube into the hole
of it from outside to inside as shown in
Fold the wings inward as shown in
Clamp Tube
Wings of Clamp Tube
Figure 4-83. Installing the Clamp Tube
When installing the Ink Supply IC Holder Assy, make sure to
remove slack around the section B by moving the Carriage Unit
between the 0-digit side and the 80-digit side a few times.
Figure 4-84. Installing the Ink Supply IC Holder Assy
For routing the FFCs, see
After removing/replacing the Ink Supply IC Holder Assy, make the
A D J U S T M E N T
R E Q U I R E D specified adjustments. (See
Revision G
Fig. 4-83.
Fig. 4-83.
Convex of Clamp Tube
Hole on Clamp Tube
Section B
"4.4 Routing FFC/cables" (p.196).
Chapter 5 "ADJUSTMENT".)
Confidential
146