Epson Artisan 810 Service Manual page 151

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Paper feed defect will occur if the flap of the Lower ASF Paper
Guide Assy comes off; therefore, take care in the following
points to make sure that the flap is surely attached when
installing the Lower ASF Paper Guide Assy.
• Make sure that the shaft of the flap is surely installed.
• Make sure that the ribs (x2) of the flap are positioned on the
rear of the Lower ASF Paper Guide Assy.
Rear side
Figure 4-95. Installing the flap
DISASSEMBLY/ASSEMBLY
Rib
Flap
Flap's shaft
Disassembly Procedures
4.2.5.8.1 Reassemble of Lower ASF paper guide assy
Reassemble Lower ASF Paper Guide assy following the procedure
C A U T I O N
and check printer normally functions or not when disassembling
the Lower ASF Paper Guide Assy.
Scratches on Ultra Glossy Photo Paper by feed roller due to decrease
W A R N I N G
of ASF paper feed ability will occur if not reassemble the Lower ASF
Paper Guide Assy following the procedure after disassembling it.
Therefore, reassemble Lower ASF Paper Guide Assy following the
procedure and make sure no scratches on paper by paper feed test
with Ultra Glossy photo paper after reassemble Lower ASF Paper
Guide Assy.
Revision G
151
Confidential