Epson Artisan 810 Service Manual page 157

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Follow the procedure below to install the Waste Ink Tray Assy.
1. Mark the whole circumference of the Waste Ink Tube 51
mm from the end of the tube.
2. Insert the Tube Stopper up to the marking taking care not
to cover the marking.
When inserting the Tube Stopper, take care not to rub the
marking with it inserted over and over so as to avoid
erasing it.
Mark it 51 mm
from the end
(whole
circumference).
Figure 4-106. Waste Ink Tube and Tube Stopper
3. Insert the Waste Ink Tube to the Waste Ink Cover, and
secure the Tube Stopper to the Waste Ink Cover.
4. Align and insert the ribs (x3) of the Waste Ink Tray Assy to
the holes (x3) of the Base Frame, and secure the assy with
the hook (x1) and screw (x1). (See
Fig. 4-107.)
Waste Ink Tray Assy
Figure 4-107. Installing the Waste Ink Tray Assy
DISASSEMBLY/ASSEMBLY
Waste Ink Tube
51 mm
Tube Stopper
Fig. 4-104, Fig. 4-105,
Rib & hole
Disassembly Procedures
5. Release the carriage lock, and move the Carriage Unit to
the center. (See 4.2.5.1 Printhead Step2
6. While lighting inside from the hole of the Upper Housing
with a penlight or the like, check the Waste Ink Tube for
the two points shown in Fig.
Tray Assy again if it is not installed correctly.
OK
Waste Ink
Cover
4 mm
or more
4 mm
or less
1.The marking must be seen
with Tube Stopper installed,
Tube
and the gap between
Stopper
marking and Tube Stopper
must be 4 mm or less.
2.Waste Ink Tube must
Waste Ink
Tube be set straight.
Artisan 810/835/837/ Artisan 710/725/730/
PX810FW/TX810FW/ PX710W/TX710W/
PX820FWD/TX820FWD/ PX720WD/TX720WD/
PX830FWD PX730WD/TX730WD
Light inside from these hole to
check Waste Ink Tube.
Figure 4-108. Checking the Waste Ink Tube
Revision G
(p134).)
4-108. Install the Waste Ink
NG
157
Confidential