Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
• The EJ Frame Assy must be lowered most.
80 column side
Confirm they are set here.
Figure 5-35. Position of EJ Frame Assy
• Check that the PG cams; located on both the left side and the right side of the
Carriage Shaft and the CR guide plate, are in the PG-position.
Left side
Right side
Figure 5-36. PG position when adjusting
ADJUSTMENT
Adjustment procedure
1.
Move the carriage to the home position.
0 column side
2.
Loosen all the screws the secure each parallelism adjustment bushing.
3.
Attach the parallelism adjustment jigs to the printer mechanism.
Place the rear of Jig on
( Fig. 5-36 )
Carriage Shaft.
Location of the bits of dial gauge (A) (B)
Adjustment without Using Adjustment Program
Location of the bits of dial gauge (C) (D)
Place Jig aligning the bits with the ribs shown above.
B
A
B
A
Place Jig aligning the bits with the ribs shown above.
Figure 5-37. Installing the parallelism adjustment jigs
Revision G
( Fig. 5-34 )
D
C
D
C
Place the front of Jig on CR
Guide Plate.
Confidential
231