Cr Scale - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
Taking the top left corner of the Panel Sheet as the reference
point, align the top edge with the top rib of the Panel Unit and
put the left edge against the rib, then attach the Panel Sheet.
(See Fig. 8-18 (p269).)
Secure the Panel FFC and ferrite core to the Panel Shield Plate
with double-sided tape. (See
Fold the Panel FFC at the fold line, and route it through the
marking on the Panel Shield Plate. (See
After removing/replacing the Panel Unit, make the specified
A D J U S T M E N T
R E Q U I R E D
adjustments. (See
After replacing the Panel Unit, be sure to perform the required
lubrication. (See Chapter 6
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD
Fig. 8-9 (p267).)
Fig. 8-13 (p268).)
8.4 "Adjustment" (p274).)
"MAINTENANCE".)

8.3.2.4 CR Scale

This section describes the disassembly/reassembly procedures of the
C H E C K
CR Scale for Artisan 835/837/725/730/PX820FWD/TX820FWD/
P O I N T
PX830FWD/PX720WD/TX720WD/PX730WD/TX730WD.
Parts/Components need to be removed in advance:
ADF Unit (Artisan 835/837/PX820FWD/TX820FWD/PX830FWD only)/Scanner
Unit/Upper Left Housing/Paper Guide Top Assy/Upper Housing
Removal procedure
Do not touch the CR Scale with bare hands.
C A U T I O N
Do not damage or contaminate the CR Scale.
Take care not to damage (extend too much) the Torsion Spring
16.43.
1. Release the Carriage Lock and move the Carriage Unit to 80-digit side. (See
4.2.5.1 Printhead Step2
2. Release the right side of the CR Scale from the hook on 0-digit side of the frame.
3. Remove the CR Scale from the hooks (x2).
Step 2
CR Scale
Carriage Unit
Disassembly/assembly
(p134).)
Hook
Step 3
Step 1
Figure 8-19. Removing the CR Scale (1)
Revision G
Hooks
CR Scale
270
Confidential