Left Housing/Decoration Belt L - Epson Artisan 810 Service Manual

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD

4.3.1.5 Left Housing/Decoration Belt L

Because the parts to remove differ between models, see below for
C H E C K
other than Artisan 710/725/PX710W/TX710W/PX720WD/TX720WD.
P O I N T
Artisan 810/835/PX810FW/TX810FW/PX820FWD/TX820FWD:
4.2.3.7 Left Housing / Decoration Belt L (p.117)
Artisan 837/730/PX830FWD/PX730WD/TX730WD:
9.4.2.5 Left Housing (p.298)
Parts/Components need to be removed in advance:
Scanner Unit/Upper Left Housing/Paper Guide Top Assy/Upper Housing/Rear
Left Housing
Removal procedure
1. Remove the Decoration Belt.
2. Remove the screws (x2) that secure the Left Housing.
Left Housing
Figure 4-169. Removing the Left Housing/Decoration Belt L (1)
DISASSEMBLY/ASSEMBLY
Decoration Belt
C.B.P. 3x10 (6±1Kgfcm)
C.B.A. 3x6 (black)(6±1Kgfcm)
Disassembly/reassembly procedures specific to Artisan 710/PX710W/TX710W
So as to make description easier, the printer in the photographs is
C A U T I O N
placed vertically in the following steps. Be careful about ink spilling
if the printer is tilted in practical operation.
3. Release the hooks (x3) on the bottom and dowel (x1) on the front side of the
Left Housing, and remove the Left Housing in the direction of the arrow.
Left Housing
Figure 4-170. Removing the Left Housing/Decoration Belt L (2)
Align and insert the rib in the front inside of the Left Housing to
the inside of the rib of the Base Frame.
Rib of the Left Housing
Figure 4-171. Installing the Left Housing
Align the positioning hole of the Left Housing with the dowel of
the Base Frame. (See
Revision G
Positioning hole
& dowel
The ribs of Left
Housing and the Base
Frame are inside.
Hook
Rib of the Base Frame
Fig. 4-170.)
Confidential
185