Epson Artisan 810 Service Manual page 154

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
3. Lift the CDR Tray Assy on the side with arms, remove the CDR Tray Assy to
the rear side of the printer.
Rear side
Right arm
Groove on the CDR Guide
Figure 4-100. Remove the CDR Tray Assy (2)
DISASSEMBLY/ASSEMBLY
CDR Tray Assy
Left arm
Dowel on the right arm
CDR Tray Assy
A D J U S T M E N T
R E Q U I R E D
Disassembly Procedures
Make sure to insert the dowel of the right arm into the groove
on the CDR Guide. (See Fig. 4-100.)
Place the left arm over the right arm before installation. (See
Fig. 4-100.)
If an arm comes off, place it to the CDR Tray at an angle as
shown in Fig. 4-101, and insert the hook on the tray into the
hole of the arm, then rotate it in the direction of the arrow to
engage the arm to the tray.
Hole & hook
Figure 4-101. Reassembling the CDR Tray Assy
When installing the Spur Gear B, engage its teeth with the
grooves on the CDR Tray Assy. (See
After replacing the CDR Tray Assy, make the specified
adjustments. (See Chapter 5 "ADJUSTMENT".)
When replacing the CDR Tray Assy, make sure to carry out
the specified lubrication. (See Chapter 6
Revision G
Fig. 4-99.)
"MAINTENANCE".)
154
Confidential