Epson Artisan 810 Service Manual page 201

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
STACKING THE HEAD FFC
(ARTISAN 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
PX830FWD)
Secure the Head FFCs (x4) and the CR Encoder FFC with double-sided tape, stack
them up in numeric order from inside shown in
No. FFC/cable name
1 CR Encoder FFC
2 Head FFC (x4)
Note * : See Fig. 4-196 for the connector positions on the Main Board.
Attach Clamp Tubes (x2) to the Tube
Clamp Tube
Guide Outer with double-sided tape.
6
3
Tube Guide Outer
5 2
Tube Guide Sub
4 1
Tube Guide Inner Head FFC
Double-sided tape
Figure 4-204. Stacking the Head FFC
(Artisan 810/835/837/PX810FW/TX810FW/PX820FWD/TX820FWD/
DISASSEMBLY/ASSEMBLY
Figure 4-204, and route them.
CN No. * Remarks
Ferrite core (x1)
CN6
(See Fig. 4-44)
CN1,2,3,4 ---
Confirm that the CR Encoder is
attached to the Carriage Unit with
double-sided tape (x4).
110 mm
90 mm
CR Encoder FFC
Head FFC
Attach the Sheet Slider to the
Head FFC where the Ink Tube
touches the FFC.
Sheet Slider
Sheet Slider
PX830FWD)
STACKING THE HEAD FFC
(ARTISAN 710/725/730/PX710W/TX710W/PX720WD/TX720WD/
PX730WD/TX730WD)
Secure the Panel FFC, the Head FFCs (x4) and the CR Encoder FFC with double-sided
tape, stack them up in numeric order from inside shown in
4-205, and route them.
No. FFC/cable name
1 Panel FFC
2 CR Encoder FFC
3 Head FFC (x4)
Note * : See Fig. 4-198
See Fig. 4-204 for
stacking the Head
FFCs (x4) and CR
Encoder FFC.
(Artisan 710/725/730/PX710W/TX710W/PX720WD/TX720WD/PX730WD/
Routing FFC/cables
Figure 4-204
CN No. *
CN33
CN6
CN1,2,3,4
for the connector positions on the Main Board.
Secure this section to the Panel Unit
and Front Frame. (See
Panel FFC
Figure 4-205. Stacking the Head FFC
TX730WD)
Revision G
and Figure
Remarks
Ferrite core (x1)
(See Fig. 4-203)
---
---
Fig. 4-166.)
Secure this section
to the Head FFC.
Double-sided tape
201
Confidential