Epson Artisan 810 Service Manual page 271

Epson Artisan 810/835/837/710/725/730/Epson Stylus Photo PX810FW/TX810FW/PX820FWD/TX820FWD/PX830FWD/PX710W/TX710W/PX720WD/TX720WD/PX730WD/TX730WD
4. Move the Carriage Unit to the center.
5. Pull out the CR Scale from the slit of the CR Encoder Sensor.
Slit of CR Encoder Sensor
Figure 8-20. Removing the CR Scale (2)
6. Detach the Torsion Spring 16.43 from the hook of the Main Frame.
7. Rotate the CR Scale 90 degrees as shown below, and remove it from the Main
Frame.
90 degrees
Cutout
Leg B
Rib
Leg A
Torsion Spring 16.43
Figure 8-21. Removing the CR Scale (3)
Artisan 835/725/PX820FWD/TX820FWD/PX720WD/TX720WD
CR Scale
Chipped part
Torsion Spring 16.43
CR Scale
Hook
Attach the CR Scale to the hook on the left of the printer with
the chipped part upward. (See
When installing the Torsion Spring 16.43, follow the procedure
below. (See
1.
2.
3.
Make sure to put the CR Scale through the slit of the CR
Encoder Sensor. (See
Be sure to install the CR Scale on to the hooks (x2). (See
8-19.)
Disassembly/assembly
Fig. 8-21.)
Fig. 8-21.)
Attach the leg A to the hole of the CR Scale.
Attach the Torsion Spring 16.43 to the rib on the Main
Frame.
Attach the leg B to the cutout of the Main Frame.
Fig. 8-20.)
Revision G
Fig.
271
Confidential