Connecting And Using Ecg - Siemens ACUSON Cypress Operator's Manual

Stress Echo
8-2
Connecting and Using
Use to display electrocardiogram waveforms. Siemens provides an
ECG
adapter that connects into the back of the Cypress system.
WARNING The Cypress system is not intended for use as an
for diagnostic
triggering only.
WARNING Do not use
have exposed male pins. Electrocution could result if these pins
are plugged into
To connect the Cypress system to a stress system, follow these steps:
Assemble the supplied
1.
System plug as shown in Figure 36, "ECG-to-BNC Connector and BNC-to-
Stress System Plugs," on page 8-4 and Figure 37, "Stress Echo ECG Cable,"
on page 8-5.
Insert the -to-
ECG
2.
system.
Insert the -to-Stress System plug into your stress system.
BNC
3.
– o
Attach the electrodes and
4.
ACUSON Cypress™ Operator's Manual
ECG
. Signals displayed are for reference or
ECG
patient cables with detachable lead wires that
ECG
power.
AC
-to- connector, cable, and
ECG BNC
connector into the port on the back of the Cypress
BNC
CONNECTIONS
(SEE Figure 36 on
leads to the patient.
ECG
BNC
ECG CABLE
SUPPLIED BY
SIEMENS
page 8-4)
ECG
monitor or
ECG
-to-Stress
CONNECTS
TO YOUR
STRESS
SYSTEM