Trimming Frames From A Loop; Save And Label Loops From Freeze Mode - Siemens ACUSON Cypress Operator's Manual

Trimming Frames from a Loop

The yellow bar located in the upper right corner of each quad represents the
length (in frames) of the currently displayed loop. If the
nected and displayed in the quad, the loop contains 14 frames.
To trim frames from the start or end of a loop, follow these steps:
Turn the
SEL QUAD
1.
Press the
END/START
2.
loop, or Start to trim frames from the start of the loop.
Turn the
END/START
3.
visible.
NOTE: Trimming frames does not delete the frames—turn the
knob in the opposite direction to display the frames.

Save and Label Loops from Freeze Mode

To save and label loops from Freeze mode, follow these steps:
Press the
PATIENT
1.
Click [
NEW PATIENT
2.
Press the mode key to save the patient information and exit the Setup
2D
3.
screen.
Press the function key and click [
TOOLS
4.
Turn the
PROTOCOL
5.
you want to capture. For example, to capture the
knob to display RestLAX.
TOCOL
Scan the patient and when the best images are displayed, press
6.
NOTE: The Cypress system will temporarily store numerous loops—the
number of loops depends on the patient's heart rate and the amount
of time between the last mode change and when the
pressed.
Turn the
PLAY LOOP
7.
Position the .
ROI
8.
Press or •
Q SAVE
9.
the view counter.
ACUSON Cypress™ Operator's Manual
knob to highlight the quad.
knob to display End to trim frames from the end of the
knob until the desired frames of the loop are no longer
function key.
]. Select the stress protocol from the drop-down menu.
knob to display the Stage and View label of the first loop
Soft Window knob until the best image is playing.
to capture the loop. A "1" will appear next to LAX in
SAVE
is properly con-
ECG
] to display the region of interest.
ROI
view first, turn the
LAX
FREEZE
Labeling Views
END/START
PRO-
.
FREEZE
key is
8-25