Hipath1120/1150 Wall Mounting Instructions; Figure 4-14 Mounting Hipath 1120 On The Wall - Siemens HiPath 1100 Service Manual

Installation

HiPath1120/1150 Wall Mounting Instructions

4.6 HiPath1120/1150 Wall Mounting Instructions
Step
1. Drill a hole in the wall at a height of 4.10 ft (1.25 m) from the floor.
2. Place the bushing over the hole then insert the screw and tighten it until only 0.19"
(5 mm) protrude.
Hang the system at the top of ➀, on the screw (see Figure 4-14 and Figure 4-15).
3.
Mark additional holes for washers ➁ and remove the system.
4.
5. Drill the remaining holes as marked, install washers and screws, then tighten them
letting 0.19" (5 mm) protrude.
6. Hang the system again and align it by tightening the lower screws.
Back of the enclosures
Figure 4-14 Mounting HiPath 1120 on the wall
4-14
Procedure
A31003-K1160-S100-03-7620
Service Manual