On The Hipath 1150; Figure 4-25 Installing A Ctr- Up0/E Hipath 1120 Module - Siemens HiPath 1100 Service Manual

Assembly Diagram
Figure 4-25 Installing a CTR- U
4.7.7.2

On the HiPath 1150

Installation Procedures
Step
1. Remove the power supply.
2. Remove the Main Distribution Frame's cover.
3. Remove the backplane.
4. Remove the slots above the MB.
5. Attach the module to the pin connector on the MB.
6. Reassemble the entire set.
7. "Performing a Visual Inspection" on page 4-59.
8. Turn on the power supply.
9. Configure the required data (see "Operation" on page 6-1).
A31003-K1160-S100-03-7620
Service Manual
Installation of Expansion and Option Modules
HiPath 1120 Module
P0/E
Procedure
Installation
4-31