Configuring the system specifically for the client
Comments about the System's Programming Codes
.
The name assigned to these numbers can have up to 15 characters.
Emergency Numbers are not affected by the ACS feature.
Emergency calls never use external lines configured for:
Internet access
●
An absent external line
●
An external line configured to accept only incoming calls
●
Module Detection (061)
This setting specifies the slots to which new modules are connected, so that the system may
detect them.
The modules can only be connected/disconnected when the system is turned off.
If the option "Detect all slots" is selected, the system will detect the components in the following
order:
1 - External lines/digital extensions
2 - External lines/analog extensions
This means that if there was a previous configuration in which the order of analog lines/
extensions was specified, that order will be changed when a TME1 or S0 modules is added to
the system.
Example: In a HiPath 1150 system that has only a MB Module (2 external lines and 10 analog
extensions) the numbering pattern will be 801 and 802 for the external analog lines, and 11 to
20 for the analog extensions. The insertion of a S0 module produces the following configura-
tion:
- 801 to 805 for the external digital lines
- 806 and 807 for the external analog lines
- 11 to 15 for the ISDN extensions
- 16 to 25 for analog extensions
- Extension 16 as the Programming extension.
If "Detect only specified slot" is selected, the existing numbering configuration will remain. Only
the module will be detected by the system.
7-50
A31003-K1160-S100-03-7620
Service Manual