Siemens HiPath 1100 Service Manual page 296

Configuring the system specifically for the client
Comments about the System's Programming Codes
Call Detail Report Filter (167)
The number programmed in this filter specifies the type of outgoing call to be recorded, based
on the first four digits of the dialed number.
For example, in order to record only outgoing international calls you must program the digits
"00." The maximum number of digits is 4.
In the default setting a digit sequence is not configured.
Call Detail Report with a Serial Interface (006)
This setting specifies that the Call Detail Report will be done through a serial interface.
CommServer does not work when this setting is enabled.
A31003-K1160-S100-03-7620
7-58
Service Manual