Operation
Programming the system using a PC
6.2.2
Remote or Local Connection
6.2.2.1
External Analog Modem
For this option, the HiPath 1100 applications are installed. After restarting the computer
configure the settings on CommServer, HiPath 1100 Manager and the HiPath 1100 system.
Procedure:
1.
Connect the analog modem (to connect the modem's extension, see item 4.7 - Connecting
Extensions to the System's Internal MDF) as follows:
REMOTE
ADMINISTRATION
LOCATION
HiPath 1100 Applications
Manager
Billing
CommServer
Figure 6-8
External analog modem connection
2.
Insert the HiPath 1100 CD in the CD drive;
If Auto-Run is not configured, go to the Start menu on Windows, click "Run" and then select
the "Browse" button in the dialog box. Open the file SETUP.EXE on the CD drive.
3.
In the Setup window, select the language you want to use
4.
A window will appear where you can select the software to be installed
5.
Install your selected software components sequentially. For programming the HiPath 1100
system, the following applications must be installed:
HiPath 1100 Manager and
●
CommServer (installs automatically).
●
6.
After installation of each component, a message is displayed indicating that the installation
was successfully completed. Click "Next" every time it appears;
6-13
Public Network
ANALOG MODEM
EXTERNAL OR
INTERNAL
Software
Transmission
Status Monitor
HiPath 1100
ADMINISTERED
HiPath 1100
Serial
Cable
ANALOG MODEM
EXTERNAL LINE
A31003-K1160-S100-03-7620
Service Manual
Extension
Modem