Siemens HiPath 1100 Service Manual page 277

Caller ID for analog extension (CLIP) (010)
When this feature is enabled and the extension receives an incoming call, the DTMF generator
will send a signal and display the callers information at the extension. When a E805C (Brazil)
or a Gigaset 4010 telephone is used, the Caller ID information is shown on the display.
Electronic Lock Password Reset (126)
It allows resetting the default password (00000) for the Electronic Lock in the event the user
has changed or forgotten the password.
Timeout when there is no answer (130)
This setting specifies the time duration for external calls to ring at an extension before being
transferred to a second attendant, in case that there is no answer (*14).
Dialing Mode (168)
This setting specifies the dialing mode to be used by each extension or whether the dialing
mode should be detected automatically. The dialing modes are: pulse (DP) and tone (MF).
Flash Detection Time (131)
The Flash signal generated by a Standard MF telephone will only be detected if it is within the
range configured for the system.
Therefore, it is recommended that you check the Flash detection time of MF telephones and
adjust the settings to approximate them as much as possible.
The configurations for detection of Flash may vary depending on the country.
The system has the capability for Automatic Flash Detection.
Overflow/Escape Extension (132)
An overflow extension only receives calls when the extension that was called is not available,
does not answer or was not programmed.
The overflow extension can be accessed through the specified internal number and
cannot be used or programmed as a Fax extension.
A31003-K1160-S100-03-7620
Service Manual
Configuring the system specifically for the client
Comments about the System's Programming Codes
7-39