Installation
Installation of Expansion and Option Modules
4.7.9.2
On the HiPath 1150
Figure 4-30
Installing a Power Supply Unit HiPath 1150
Procedure after Installation
Step
1.
Check network voltage
2.
If the voltage is within the power supply's voltage range, connect the power supply.
3.
Use the power input on power supply units when available.
4.
"Performing a Visual Inspection" on page 4-59
5.
Configure the required data (see "Operation" on page 6-1).
Warning
!
To turn the power on or off to the system use the cable of the power supply.
4-36
Procedure
A31003-K1160-S100-03-7620
Service Manual