Mitsubishi Electric CR750-Q Instruction Manual page 104

3Explanation of operation methods
<PARAMETER>
DATA
(100.00
Prev
DATA
<PARAMETER>
DATA
(0.00,0.00,100.00,0.00,0.00,0.00 )
Prev
DATA
The value can be changed also in this state.
Press the function key corresponding to the "DATA", make it move to the position of the element
number which changes the cursor by the arrow key, and input the new preset value. Delete the
unnecessary number by the [CLEAR] key.
<PARAMETER>
DATA
(0.00,0.00,0.00,0.00,0.00,0.00 )
Prev
DATA
If the [EXE] key is pressed, the buzzer will sound, the value will be fixed and it will return to the
screen of the parameter.
If the function key corresponding to the "CLOSE" is pressed also after inputting the new preset value,
change can be canceled and it can return to the parameter screen.
Power must be turned ON again
The changed parameter will be validated only after the controller power has been turned OFF and ON once.
Only display is valid during program execution.
If the setting value of the parameter is changed during execution of the program, the error will occur. (Even
if the error occurs, execution of the program does not stop)
Display the parameter near the name of the inputted parameter.
Even if the name of the parameter does not input all characters correctly, it displays the parameter near the
inputted name automatically.
3-84 Operation of parameter screen
NAME(MEXTL )
ELE(3 )
)
Next CLOSE
123
NAME(MEXTL )
ELE( )
Next
CLOSE
123
NAME(MEXTL )
ELE(3 )
Next CLOSE
123
[F3]
<PARAMETER>
DATA
(0.00,0.00,0.00,0.00,0.00,0.00 )
Prev
DATA
[F2]
<PARAMETER>
0.00,0.00,100.00,0.00,0.00,0.00
Prev
DATA
NAME(MEXTL1 )
ELE( )
Next CLOSE
123
(MEXTL ) ( )
Next CLOSE
123