Mitsubishi Electric CR750-Q Instruction Manual page 666

7Appendix
Fig.7-59:Circular interpolation
■Interpolation settings
Set the "Operation mode", "Cancel angle" and "Straight ratio" for the spline interpolation.
When the menu [Tool] → [Interpolation settings] is clicked, the interpolation settings set in the spline file on
the active Spline File Edit screen appear in the setting screen.
Fig.7-60:Interpolation settings screen
If the [OK] button is clicked after changing the settings, the changes will be saved and the setting screen will
close. If the [Cancel] button is clicked, the setting screen will close without saving the changes. The setting
range for each item is shown in
Table 7-14:Setting range for interpolation setting items
Item
Operation mode
Cancel angle
Straight ratio
Appendix-646 Spline interpolation
Table 7-14.
Setting range
Constant linear speed/variable linear speed
0 to 180 [deg]
0 to 100 [fold]
Default value
Constant linear speed
120
8