Panasonic 1M Operation Manuals page 84

Note
Use the system after confirming that each device is properly installed.
Disarming the security alarm (when the security alarm/security preliminary alarm is active: disarm the alarm)
1
Touch
while the security preliminary
alarm or security alarm is active
The security number input screen appears.
If no operation is performed for 10 seconds, the
Note
system goes back to the security alarm status In
that case, repeat the procedure from Step
If no security number is set, the security alarm
status is disarmed.
It is not necessary to perform Step
subsequent steps.
2
Enter the security number
The entered security number is displayed
on the screen.
Please enter the set security number.
Touch
Note If you make a mistake when entering the number,
touch
3
Touch
If the Security Number is correct, the
Security light turns off and the alarm is
disarmed. The message "Security has been
turned off." appears on the screen. After 3
seconds have elapsed, the screen changes
to Standby status and then to the Mode
Selection Screen. Please select Living Mode.
If the wrong security number is entered, the
screen returns to the Security Number Input
Screen. If this happens, repeat the
procedure from Step
Installer
Setting
It is possible to sound the alarm notification
message when disarming the alarm.
Message details: "Security has been turned off."
Consult with the company that installed the system
or the administrating company.
84
on the base unit
2
and the
.
. This clears all numbers.
2 .
When the Security Alarm Is Activated
1 .
火災
確認
FIRE CONFIRM
メニュー
MENU
終了
OFF
電源
警戒
SET
POWER
The security alarm
indicator
lamp flashing in
green
Security number input screen
Confirmation screen
Touch the
keypad
Touch