Activating The Emergency Alarm - Panasonic 1M Operation Manuals

Activating the Emergency Alarm

Note
Use the system after confirming that each device is properly installed.
If the Emergency button or an expanded Emergency button is pressed
When the Emergency button or an expanded
Emergency button is pressed, the base unit
and the cordless handset of the door phone
report the state of emergency.
(pee-paw, pee-paw, pee-paw)
Emergency.
電源
Gas Not Home Alarm Lock
GAS NOTHOME SET
POWER
The emergency indication will turn off after
approximately 3 minute and the periphery of
the MENU button will flash in red.
If the pressed emergency button is restored,
the alarm message automatically stops, and
the periphery of the MENU button and the
alarm indicator lamp on the handset of the
door phone will turn off.
●The Emergency button, the periphery of the
Note
MENU button and the alarm indicator lamp
will keep flashing until the pressed
emergency button is restored.
●It is also possible to turn off the emergency
indication within 3 minutes. (
●If the expanded emergency button is
pressed, the emergency button on the base
unit will not flash.
How to stop the alarm message
Press the Alarm Stop button. (It is also
possible to stop the alarm sound from the
manager room.)
Measures taken when alarm is sounding
Check the details on the
alarm and take necessary
measures such as
notifying neighbors
of the alarm.
The Emergency
button flashing
in red
非常
EMERG.
Alarm Stop
復旧/警報音停止
RESET/STOP ALARM
button
火災
確認
FIRE CONFIRM
メニュー
MENU
MENU button
終了
OFF
OPEN
解錠
Handset of the door phone
UNLOCK
Alarm indicator lamp
Flashing in red
通話
TALK
Alarm sounding
Page 75)
非常
EMERG.
警報音停止
非常
EMERG.
復旧/警報音停止
RESET/STOP ALARM
火災
確認
FIRE CONFIRM
メニュー
MENU
終了
OFF
電源
POWER
解錠
UNLOCK
通話
TALK
How to restore the emergency button on the base unit
Press the Emergency button again.
The Emergency button will turn off.
How to restore an expanded Emergency button
Push the pressed button again.
Or pull the drawstring again.
In case of WTF4510W
Open the Emergency button and restore
the protection board.
Remove the cover.
1
2 Pull back the button.
2
Button
Set the protection board back
3
to the original position and
place it inside the main unit.
Back of the cover
3
Press
and Restore
Installer
Setting
●It is also possible to disable the alarm
message playback. (the alarm will still
appear on the display.)
●It is possible to delay the report to the
manager room and the handset of the door
phone for 30 seconds.
Consult with the company that installed the
system or the administrating company.
非常
EMERG.
1
Cover
Protection board
85