Setting The Security Alarm When Sleeping At Home - Panasonic 1M Operation Manuals

Shortening the Alarm Delay Time Using the Handset of the Door Phone
By performing the following operation on the handset of the door phone, you can immediately set the security
alarm for the front door and windows before the alarm delay time has elapsed.
1 Set the security alarm on the base unit and go out from the Unit Entrance
Go out from the Unit Entrance within the alarm delay time. ( Page 97)
Note
Make sure to set the alarm on the base unit.
2
Press and hold down the Call button on the
handset of the door phone for 2 seconds or more
The alarm indicator lamp on the handset of the door phone lights in red for
approximately 10 seconds and the security alarm is immediately set. It is
possible to play the message or the notification sound from the handset of the
door phone when setting the security alarm.
( External Security Door Phone Sound setting (pages 61, 63 and 64).
If the security alarm cannot be set, the security alarm lamp
Note
on the handset of the door phone flashes in red.

Setting the Security Alarm When Sleeping at Home

1
Close and lock the front door and windows
to which the magnet switches are installed
2
Press the MENU button in the standby
status (nothing is displayed on the screen)
3
Touch
4
Touch Home Mode or Sleeping Mode
in Living Mode
* If the security setting is not set to "ON", it is not possible
to activate the security alarm. (See
The message "Security has been turned on." appears and
the alarm setting is enabled immediately for the windows and
60 seconds later for the front door. factory default setting)
Note
●Make sure to completely close and lock the windows
and front door before setting the security alarm.
●If the security alarm is set when a window or unit door (with
a magnet switch installed) left open, short beeps are
generated from the base unit and extension speakers, and
the alarm lamp flashes in green. If the window or front door
is closed and locked at this point, the security alarm is set.
●Due to magnet's specification, the security alarm may be
set without completely closing the front door or windows.
Make sure to completely close and lock the front door
and windows before setting the security alarm.
Installer
Setting
It is possible to play the alarm notification message
when it enters into the security alarm status.
Message details: "Security has been turned on."
Consult with the company that installed the system or
the administrating company.
in the Top Menu
pages 19-20)
Cordless handset of
the door phone with
a camera
The alarm indicator
lighting in red (for
about 10 seconds)
holding down for 2
Standby status
非常
EMERG.
復旧/警報音停止
RESET/STOP ALARM
火災
確認
FIRE CONFIRM
メニュー
MENU
終了
OFF
電源
POWER
解錠
UNLOCK
通話
TALK
Top Menu
電源
電源 FIRE ガス GAS 留守 NOTHOME 警戒 SET 戸締り OPEN
POWER
The alarm lamp lighting in green
After about 3 seconds
Goes into the standby status.
Pressing and
or more seconds
MENU button
Press
Touch
火災
確認
FIRE CONFIRM
メニュー
MENU Touch
any one
終了
OFF
101