Configuration Guidelines; Configuration Example - Lenovo RackSwitch G8264 Application Manual

Configuration Guidelines

Configuration Example

1. Select a VLAN and define the Private VLAN type as primary.
2. Configure a promiscuous port for VLAN 700.
3. Configure two secondary VLANs: isolated VLAN and community VLAN.
4. Map secondary VLANs to primary VLAN.
170
G8264 Application Guide for ENOS 8.4
The following guidelines apply when configuring Private VLANs:
 Management VLANs cannot be Private VLANs. Management ports cannot be
members of a Private VLAN.
 The default VLAN 1 cannot be a Private VLAN.
IGMP Snooping must be disabled on Private VLANs.

 All VLANs that comprise the Private VLAN must belong to the same Spanning
Tree Group.
 A VLAN pair consists of a primary VLAN and one associated secondary VLAN
(isolated or community). The maximum number of VLAN pairs per port is 16.
Follow this procedure to configure a Private VLAN.
RS G8264(config)# vlan 700
RS G8264(config­vlan)# private­vlan primary
RS G8264(config­vlan)# exit
RS G8264(config)# interface port 1
RS G8264(config­if)# switchport mode private­vlan
RS G8264(config­if)# switchport private­vlan mapping 700
RS G8264(config­if)# exit
RS G8264(config)# vlan 701
RS G8264(config­vlan)# private­vlan isolated
RS G8264(config­vlan)# exit
RS G8264(config)# vlan 702
RS G8264(config­vlan)# private­vlan community
RS G8264(config­vlan)# exit
RS G8264(config)# vlan 700­702
RS G8264(config­vlan)# stg 1
RS G8264(config­vlan)# exit
RS G8264(config)# vlan 700
RS G8264(config­vlan)# private­vlan association 701,702
RS G8264(config­vlan)# exit