7. Configure controller 1 IP address using out‐of‐band management port:
8. Configure controller 2 IP address using in‐band management port:
9. Enable OpenFlow instance 1:
10. Create OpenFlow switch instance 2 and add data ports:
11. Configure controller 2 IP address using in‐band management port:
12. Configure controller 2 IP address using in‐band management port:
13. Enable OpenFlow instance 2:
14. View OpenFlow Configuration:
© Copyright Lenovo 2016
RS G8264(configopenflowinstance)# controller 1 address 172.20.100.73
mgtport
RS G8264(configopenflowinstance)# controller 2 address 172.22.100.73
dataport
(Switch connects with controller 2 via the in‐band management port configured in Step 5; default controller
port is used in this example)
RS G8264(configopenflowinstance)# enable
RS G8264(configopenflowinstance)# exit
RS G8264(config)# openflow instance 2
RS G8264(configopenflowinstance)# member 26,27,2834
RS G8264(configopenflowinstance)# controller 2 address 172.21.100.73
dataport
(Switch connects with controller 1 via the in‐band management port configured in Step 5; default controller
port is used in this example)
RS G8264(configopenflowinstance)# controller 2 address 172.22.100.73
dataport
Switch connects with controller 2 via in‐band management port configured in Step 5; default controller port
is used in this example)
RS G8264(configopenflowinstance)# enable
RS G8264(config)# show runningconfig
(Switch connects with controller 1 via the
out‐of‐band management port; default controller
port is used in this example)
(Create OpenFlow instance 2)
(Add dataports 26,27, and data port
range 28 through 34 as members of
OpenFlow instance 2)
Chapter 15: OpenFlow
285