Redundant Mode Configuration Example - Lenovo RackSwitch G8264 Application Manual

Redundant Mode Configuration Example

50
G8264 Application Guide for ENOS 8.4
This example shows the parameters available for configuration in Redundant
mode:
RS G8264# #easyconnect
Configure Switch Redundant mode (yes/no)? y
Note: It is recommended to select Basic system configuration in order to
set the management IP address used for vLAG health check.
Configure Basic system (yes/no)? y
Configure this switch as vLAG Primary or Secondary Peer
(primary/secondary)? prim
Select ISL Ports (Static Defaults: 1­16)?
The following ISL ports will be enabled:
ISL ports(40G) : 1­16
Select vLAG TierID (Default: 101)?
Select management IP address (Current: 192.168.49.50)?
Enter management netmask (Current: 255.255.255.0)?
Select Peer IP address for vLAG healthcheck (Default: 1.1.1.2)?
Warning: vLAG healthcheck Peer IP is not reachable.
Do you want to select another Peer IP (yes/no)? y
Select Peer IP address for vLAG healthcheck (Default: 1.1.1.2)?
Warning: vLAG healthcheck Peer IP is not reachable.
Do you want to select another Peer IP (yes/no)? n
Select Uplink Ports (Static Defaults: 17­24)?
The following Uplink ports will be enabled:
Uplink ports(1G/10G): 17­24
Select Downlink Ports (Static Defaults: 25­64)?
The following Downlink ports will be enabled:
Downlink ports(1G/10G): 25­64