5. Xmodem download: When you see the following message, change the Serial Port
90
G8264 Application Guide for ENOS 8.4
characteristics to 115200 bps:
Change the baud rate to 115200 bps and hit the <ENTER> key before
initiating the download.
a. Press <Enter> to set the system into download accept mode. When the readiness
meter displays (a series of "C" characters), start XModem on your terminal
emulator.
b. When you see the following message, change the Serial Port characteristics to
9600 bps:
Change the baud rate back to 9600 bps, hit the <ESC> key.
c. When you see the following prompt, enter the image number where you want to
install the new software and press <Enter>:
Install image as image 1 or 2 (hit return to just boot image): 1
d. The following message is displayed when the image download is complete.
Continue to step 7.
Entering Rescue Mode.
Please select one of the following options:
T) Configure networking and tftp download an image
X) Use xmodem 1K to serial download an image
R) Reboot
E) Exit
Option?: