4. Turn on VRRP and configure the Virtual Interface Router.
5. Set the priority of Virtual Router 1 to 101, so that it becomes the Master.
6. Configure the ISL ports and place them into a port LAG:
7. Configure the upstream ports.
8. Configure the server ports.
© Copyright Lenovo 2016
RS G8264(config)# router vrrp
RS G8264(configvrrp)# enable
RS G8264(configvrrp)# virtualrouter 1 virtualrouterid 1
RS G8264(configvrrp)# virtualrouter 1 interface 3
RS G8264(configvrrp)# virtualrouter 1 address 10.0.1.100
RS G8264(configvrrp)# virtualrouter 1 enable
RS G8264(configvrrp)# virtualrouter 1 priority 101
RS G8264(configvrrp)# exit
RS G8264(config)# interface port 45
RS G8264(configif)# switchport mode trunk
RS G8264(configif)# lacp mode active
RS G8264(configif)# lacp key 2000
RS G8264(configif)# exit
Note: In this case, a dynamic LAG is shown. A static LAG (portchannel) could be
configured instead.
RS G8264(config)# interface port 1
RS G8264(configif)# switchport access vlan 10
RS G8264(configif)# exit
RS G8264(config)# interface port 2
RS G8264(configif)# switchport access vlan 20
RS G8264(configif)# exit
RS G8264(config)# interface port 10
RS G8264(configif)# switchport access vlan 100
RS G8264(configif)# exit
RS G8264(config)# interface port 11
RS G8264(configif)# switchport access vlan 100
RS G8264(configif)# exit
RS G8264(config)# interface port 12
RS G8264(configif)# switchport access vlan 100
RS G8264(configif)# exit
Chapter 12: Virtual Link Aggregation Groups
223