Lldp Example Configuration - Lenovo RackSwitch G8264 Application Manual

LLDP Example Configuration

1. Turn LLDP on globally.
2. Set the global LLDP timer features.
3. Set LLDP options for each port.
4. Enable syslog reporting.
5. Verify the configuration settings:
6. View remote device information as needed.
© Copyright Lenovo 2016
RS G8264(config)# lldp enable
RS G8264(config)# lldp refresh­interval 30(Transmit each 30 seconds)
RS G8264(config)# lldp transmission­delay 2(No more often than 2 sec.)
RS G8264(config)# lldp holdtime­multiplier 4(Remote hold 4 intervals)
RS G8264(config)# lldp reinit­delay 2 (Wait 2 sec. after reinit.)
RS G8264(config)# lldp trap­notification­interval 5(Minimum 5 sec. between)
RS G8264(config)# interface port <n>
RS G8264(config­if)# lldp admin­status tx_rx(Transmit and receive LLDP)
RS G8264(config­if)# lldp trap­notification(Enable SNMP trap notifications)
RS G8264(config­if)# lldp tlv all
RS G8264(config­if)# exit
RS G8264(config)# logging log lldp
RS G8264(config)# show lldp
RS G8264(config)# show lldp remote­device
or
RS G8264(config)# show lldp remote­device <index number>
or
RS G8264(config)# show lldp remote­devices detail
(Select a switch port)
(Transmit all optional information)
Chapter 40: Link Layer Discovery Protocol
639