Slp Configuration - Lenovo RackSwitch G8264 Application Manual

SLP Configuration

© Copyright Lenovo 2016
Use the following ISCLI commands to configure SLP for the switch:
Table 48.
SLP ISCLI Commands
Command Syntax and Usage
[no] ip slp enable
Enables or disables SLP on the switch.
Command mode: Global configuration
[no] ip slp active-da-discovery enable
Enables or disables Active DA Discovery.
Command mode: Global configuration
ip slp active-da-discovery-start-wait-time <1‐10>
Configures the wait time before starting Active DA Discovery, in seconds.
The default value is 3 seconds.
Command mode: Global configuration
clear ip slp directory-agents
Clears all Directory Agents learned by the switch.
Command mode: Global configuration
show ip slp information
Displays SLP information.
Command mode: All
show ip slp directory­agents
Displays Directory Agents learned by the switch.
Command mode: All
show ip slp user­agents
Displays User Agents information.
Command mode: All
show ip slp counter
Displays SLP statistics.
Command mode: All
clear ip slp counters
Clears all Directory Agents learned by the switch.
Command mode: Global configuration
Chapter 42: Service Location Protocol
661