Selecting Profiles
© Copyright Lenovo 2016
To change the deployment profile, you must first select the new profile and then
reboot the switch.
Note: Before changing profiles, it is recommended that you save the active switch
configuration to a backup file so that it may be restored later if desired.
When you select a profile, you will see a warning message. For example, if you
select the ACL profile, you will see the following message:
Warning: Setting boot profile to "ACL" will cause FIPS, IPv6 and VM ACL
configuration to be lost in next boot and error messages will be
displayed when above configurations are restored.
Next boot will use "ACL" profile.
To view the current deployment profile, use the following command:
RS G8264# show boot
Use the following commands to change the deployment profile:
RS G8264(config)# boot profile {default|openflow|acl}
RS G8264(config)# exit
RS G8264# reload
When using a specialized profile, menus and commands are unavailable for
features that are not supported under the profile. Such menus and commands will
be available again only when a supporting profile is used.
Note: Deployment profiles other than those listed in this section should be used
only under the direction of your support personnel.
(Select deployment profile)
(To privileged EXEC mode)
(Reboot the switch)
Chapter 16: Deployment Profiles
291