Port Membership - Lenovo RackSwitch G8264 Application Manual

Port Membership

270
G8264 Application Guide for ENOS 8.4
Table 25.
Static Flow Entry Actions in OpenFlow 1.3
Action
set‐eth‐src
set‐eth‐dst
push‐vlan
pop‐vlan
push‐mpls
pop‐mpls
set‐vlan‐vid
set‐vlan‐pcp
set‐ip‐dscp
set‐mpls‐ttl
set‐mpls‐label
copy‐ttl‐out
copy‐ttl‐in
drop
Actions for static flows must be specified in the following order: set‐mpls‐ttl,
copy‐ttl‐in, pop‐mpls, pop‐vlan, push‐mpls, push‐vlan, copy‐ttl‐out, set‐field,
output.
The set‐field action includes set‐eth‐src, set‐eth‐dst, set‐vlan‐vid, set‐vlan‐pcp,
set‐ip‐dscp, set‐mpls‐label. They may be used in any order.
The output action includes output and output‐portchannel. They may be used in
any order.
Table 26.
Static Flow Entry Options
Option
max‐len
When static flow entries are configured, port membership changes are handled as
follows:
If a port is the "in‐port" or "out‐port" in a static flow entry, the port membership

cannot be changed.
When a port membership changes, the ingress bitmap of static entries with

in‐port ANY will be updated.
Description
change source MAC address
change destination MAC address
push a new VLAN tag, 0x8100
pop the VLAN tag
push a new MPLS tag, 0x8847
pop MPLS tag, 0x0800 or 0x800 (IP Ethertype)
set VLAN ID, <0‐4094>
set 802.1p priority (0‐7)
Set IP DSCP (0‐63), 6 highest bits in TOS
set MPLS TTL
Set MPLS label, <1‐0xFFFFF>
copy TTL outward ‐ from next‐to‐outermost to outer‐
most
copy TTL inward ‐ from outermost to next‐to‐outer‐
most
drop the packet
Description
maximum length of flow to send to controller