Brother HL-L5000D Service Manual page 189

(5) Release the heater harness of the fuser unit from the securing fixtures, and disconnect it
from the low-voltage heater harness.
Low-voltage heater harness
Assembling Note:
• After connecting the heater harness, pull the connector on the heater harness side
while holding the connector on the low-voltage heater harness side to make sure it is
locked.
Harness routing: Refer to
(6) Disconnect the center thermistor harness and the side thermistor harness from the eject
sensor PCB ASSY.
Note:
• When disconnecting the harness, hold the top of the PCB connector to prevent the
PCB connector being damaged.
Eject sensor PCB ASSY
Fuser unit
Side thermistor
harness
Harness routing: Refer to
Heater harness
Fig. 3-23
"6. Rear side of the machine".
<Frame L side>
Fig. 3-24
"6. Rear side of the machine".
3-44
<Frame R side>
Fuser unit
Center thermistor
harness
Confidential