Adjust Printable Range For Each Speed Level (Full Speed / Half Speed For Thick Paper / Quiet Mode) (Function Code: 46) - Brother HL-L5000D Service Manual

1.3.11 Adjust printable range for each speed level
(Full speed / Half speed for thick paper / Quiet Mode) (function code: 46)
<Function>
This function is to adjust the printing position in horizontal / vertical direction when it's
misaligned on Full speed, Half speed for thick paper, or Quiet Mode.
Position can be adjusted in 11 steps from -0.5% to 0.5% (Printing width gets smaller when
the value is negative).
<Operating Procedure>
Non touch panel models
(1) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 46" on the LCD, and
press the [OK] key. "1.PrtSzAdj
Nomal" is displayed on the LCD.
(2) Press the [▲] or [▼] key to display
desired speed on the LCD.
• Full speed → "1.PrtSzAdj Nomal"
• Half speed for thick paper →
"2.PrtSzAdj THalf"
• Quiet Mode → "3.PrtSzAdj QHalf"
Press the [OK] key. "*.1 *:Main" is
displayed on the LCD.
Selected speed is displayed for "*".
(3) Press the [▲] or [▼] key to display
"*.3 *:Print" on the LCD, and press the
[OK] key. "PRINTING" is displayed on
the LCD, and the print adjustment test
pattern (refer to the
printed on a sheet of paper.
(4) Adjust the line so that the width is
10mm in horizontal / vertical direction.
Press the [▲] or [▼] key to display
desired direction on the LCD.
• Horizontal direction → "*.1 *:Main"
• Vertical direction → "*.2 *:Sub"
Press the [OK] key. "0.0 %" is displayed
on the LCD.
(5) To make the print width smaller, press
the [▼] key to decrease the value.
Press the [OK] key after adjusting the
value.
(6) Press the [X] key to return the
machine to the initial state of
maintenance mode after adjusting the
value.
next page) is
5-25
Touch panel models
(1) Press the [4], and then the [6] key in
the initial state of maintenance mode.
"1.PrtSzAdj Nomal" is displayed on
the LCD.
(2) Press the [˄] or [˅] key to display
desired speed on the LCD.
• Full speed → "1.PrtSzAdj Nomal"
• Half speed for thick paper →
"2.PrtSzAdj THalf"
• Quiet Mode → "3.PrtSzAdj QHalf"
Press the [Mono] key. "*.1 *:Main" is
displayed on the LCD.
Selected speed is displayed for "*".
(3) Press the [˄] or [˅] key to display "*.3
*:Print" on the LCD, and press the
[Mono] key. "PRINTING" is displayed
on the LCD, and the print adjustment
test pattern (refer to the
printed on a sheet of paper.
(4) Adjust the line so that the width is
10mm in horizontal / vertical direction.
Press the [˄] or [˅] key to display
desired direction on the LCD.
• Horizontal direction → "*.1 *:Main"
• Vertical direction → "*.2 *:Sub"
Press the [Mono] key. "0.0 %" is
displayed on the LCD.
(5) To make the print width smaller, press
the [˅] key to decrease the value.
Press the [Mono] key after adjusting
the value.
(6) Press the [X] key to return the
machine to the initial state of
maintenance mode after adjusting the
value.
next page) is
Confidential