Adjusting Touch Panel (Function Code: 61) (Touch Panel Models Only); Initializing The Eeprom Of The Main Pcb Assy (Function Code: 01) - Brother HL-L5000D Service Manual

■ Firmware installation using PC
Non touch panel models
(1) Press the [OK] key and then the [Go]
key while the machine is in the ready
state. Then, press the [▲] key four
times to enter the maintenance mode.
(2) Connect the machine to your
computer using the USB cable.
(3) Open the temporary folder and
double-click "FILEDG32.EXE" to start
it, and select "Brother Maintenance
USB Printer".
(4) Drag and drop the required program
file (ex. D001GJ_A.djf or
D001GH_A.djf) in the same folder
onto the "Brother Maintenance USB
Printer" icon in the Filedrgs screen.
The file is loaded to the machine, and
installing to the flash ROM starts.
(5) When installing is completed, the
machine restarts and returns to the
ready state automatically.
(6) Repeat the procedures (1) to (5) to
install required firmwares.
(7) Turn OFF the power switch of the
machine, and disconnect the USB
cable.
1.2 Adjusting Touch Panel (Function Code: 61)
(Touch Panel Models only)
Adjust the touch panel as described in
(Touch panel models only)" in Chapter 5
1.3 Initializing the EEPROM of the Main PCB ASSY
(Function Code: 01)
Initialize the EEPROM of the main PCB ASSY as described in
parameters (function code: 01, 91)" in Chapter 5
Touch panel models
(1) Press and hold the [Home] key for
approximately five seconds while the
machine is in the ready state.
(2) Press the blank field at the bottom on
the LCD.
(3) Press the [*], [2], [8], [6], and [4] key
on the LCD in this order. The machine
enters the maintenance mode.
(4) Connect the machine to your
computer using the USB cable.
(5) Open the temporary folder and
double-click "FILEDG32.EXE" to start
it, and select "Brother Maintenance
USB Printer".
(6) Drag and drop the required program
file (ex. D001GG_A.djf) in the same
folder onto the "Brother Maintenance
USB Printer" icon in the Filedrgs
screen. The file is loaded to the
machine, and installing to the flash
ROM starts.
(7) When installing is completed, the
machine restarts and returns to the
ready state automatically.
(8) Turn OFF the power switch of the
machine, and then repeat the
procedures (1) to (7) to install required
firmwares.
(9) Turn OFF the power switch of the
machine, and disconnect the USB
cable.
"1.3.12 Adjust touch panel (function code: 61)
.
.
4-4
"1.3.1 Initialize EEPROM
Confidential