Brother HL-L5000D Service Manual page 53

First line
Size Error Specify the correct
paper size for Tray 1.
Specify the correct
paper size for Tray 2.
Specify the correct
paper size for Tray 3.
Specify the correct
paper size for Tray 4.
Size Error DX Press Cancel. Specify
the correct paper and
load the same size
paper as the Printer
driver setting.
Specify the correct
paper and press Go.
Size Mismatch Load #S paper in #T
and press Go.
Toner Low -
Scroll
When printing from paper tray 1, a
paper size not supported for paper
tray 1 was specified from the
driver.
When printing from paper tray 2, a
paper size not supported for paper
tray 2 was specified from the
driver.
When printing from paper tray 3, a
paper size not supported for paper
tray 3 was specified from the
driver.
When printing from paper tray 4, a
paper size not supported for paper
tray 4 was specified from the
driver.
A tray set to duplex printing-
incompatible size was specified in
duplex printing.
The registration rear sensor
detected that the paper fed was
smaller or larger than the specified
size in duplex printing mode.
When printing from the MP tray,
the size of paper set in the MP tray
does not match the size specified
by the driver.
When printing from the paper tray
1, the size of paper set in the
paper tray 1 does not match the
size specified by the driver.
When printing from the paper tray
2, the size of paper set in the
paper tray 2 does not match the
size specified by the driver.
When printing from the paper tray
3, the size of paper set in the
paper tray 3 does not match the
size specified by the driver.
When printing from the paper tray
4, the size of paper set in the
paper tray 4 does not match the
size specified by the driver.
Dot counter or develop roller
counter of the toner is reaching
the upper limit.
2-27
Description
Error Refer
codes to:
9702 2-80
9703 2-80
9704 2-80
9705 2-80
9701 2-80
8A01 2-75
9001 2-76
9002 2-76
9003 2-76
9004 2-76
9005 2-76
4B01 2-50
Confidential