Brother HL-L5000D Service Manual page 372


Adjust left-end print position
<Function>
In the event that the left-end print start position deviates, use this function to adjust the
position left and right. The adjustable range is -100 to 750 (1 unit = 0.084 mm = 300 dpi).
(Shifted to the left when the value is negative)
<Operating Procedure>
Non touch panel models
(1) Press the [▲] or [▼] key in the initial
state of maintenance mode to display
"MAINTENANCE 45" on the LCD, and
press the [OK] key. "USBNo." is
displayed on the LCD.
(2) Press the [▲] or [▼] key to display "X
Adjust" on the LCD, and press the
[OK] or [Go] key. "XAdjust MP" is
displayed on the LCD.
(3) Refer to <Adjustment option table>
below, press the [▲] or [▼] key to
select from the adjustment options,
and press the [OK] or [Go] key. "XAdj.
**= 0*" is displayed on the LCD.
(Selected option is shown for **.)
(4) To shift the writing start position to the
left, press the [▼] key to decrease the
value. To shift the position to the right,
press the [▲] key to increase the
value.
(5) Press the [OK] or [Go] key after
adjusting the value. "Accepted" is
displayed on the LCD. Return the
machine to the initial state of
maintenance mode.
<Adjustment option table>
Adjustment option
MP tray first side
Paper tray 1 first side
Paper tray 2 first side
Paper tray 3 first side
Paper tray 4 first side
Paper tray 5 first side
Duplex tray
"X" or "Y" is shown for *.
Touch panel models
(1) Press the [4], and then the [5] key in
(2) Press the [˄] or [˅] key to display "X
(3) Refer to <Adjustment option table>
(4) To shift the writing start position to the
(5) Press the [Mono] or [SET] key after
LCD
*Adjust MP MP tray second side
*Adjust T1 Paper tray 1 second side
*Adjust T2 Paper tray 2 second side
*Adjust T3 Paper tray 3 second side
*Adjust T4 Paper tray 4 second side
*Adjust T5 Paper tray 5 second side
*Adjust DX
5-23
the initial state of maintenance mode.
"USBNo." is displayed on the LCD.
Adjust" on the LCD, and press the
[Mono] or [SET] key. "XAdjust MP" is
displayed on the LCD.
below, press the [▲] or [▼] key to
select from the adjustment options,
and press the [Mono] or [SET] key.
"XAdj. **= 0*" is displayed on the
LCD. (Selected option is shown for
**.)
left, press the [˅] key to decrease the
value. To shift the position to the right,
press the [˄] key to increase the
value.
adjusting the value. "Accepted" is
displayed on the LCD, and the
machine returns to the initial state of
maintenance mode.
Adjustment option LCD
*Adjust DXMP
*Adjust DXT1
*Adjust DXT2
*Adjust DXT3
*Adjust DXT4
*Adjust DXT5
Confidential