(3) Loosen all clamps and release them from the securing fixtures.
Clamp
Clamps
Harness routing: Refer to
(4) Remove the four screw cup M3x8 (black) screws to remove the TT control PCB ASSY.
(5) Remove the six screw cup M3x8 (black) screws to remove the PCB shield plate. Pull out
the TT motor harness through the insulation sheet hole.
Screw cup M3x8 (black)
TT control PCB ASSY
Screw cup M3x8 (black)
Clamps
Fig. 3-153
"12. TT control PCB
ASSY".
TT motor harness
PCB shield plate
Screw cup M3x8 (black)
Insulation sheet hole
Fig. 3-154
3-158
Clamp
Clamps
Screw cup M3x8 (black)
Confidential