Brother HL-L5000D Service Manual page 216

(4) Remove the screw pan M4x8 screw, washer spring 2-4, and washer 5 to remove the
ground harness.
(5) Remove the taptite flat B M3x10 screw, and remove the inlet.
Heater harness
Ground harness
Screw pan M4x8
<For models with China>
Washer 5
Assembling Note:
• Attach the inlet as shown in the figure above.
• Insert the heater harness into the housing.
• For safety purposes, attach the washer spring 2-4 and washer 5 securely at
positions described in the figure above.
• For safety purposes, perform the harness routing properly as described in
side of the machine".
• The harness routing diagrams of the models for China are also included in the link.
Housing
Inlet
Washer 5
Washer spring 2-4
Heater harness
Ground harness
Washer spring 2-4
Screw pan M4x8
Fig. 3-59
3-71
1
2
Taptite flat B M3x10
Housing
"6. Rear
Confidential