Siemens SINUMERIK 840Di Diagnostic Manual page 138

Overview of Alarms
NCK alarms
10792 Channel %1 block %2 illegal interpolation type during linear
programming with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: Only spline or linear interpolation is permitted for programming two straight lines with angle
specification. Circular or polynomial interpolation is not allowed.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10793 Channel %1 block %2 second block missing during linear programming
with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The second block is missing during programming of two straight lines with angle specification. This
situation only occurs if the first subblock is also the last block of a program, or if the first subblock is
followed by a block with a preprocessor stop.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
10794 Channel %1 block %2 angle specification missing in 2nd block during
linear interpolation with angles
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The angle is missing from the second block during programming of two straight lines with angle
specification. This error can only occur if an angle was programmed in the preceding block, but no
axis of the active plane was programmed in that block. The cause of the error may therefore also have
been the intention to program a single straight line with an angle in the previous block. In this case,
exactly one axis of the active plane must be programmed.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-138
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006