Siemens SINUMERIK 840Di Diagnostic Manual page 292

Overview of Alarms
NCK alarms
16692 Channel %1 block %2 following axis/spindle %3 maximum number of
couplings in the block %4 has been exceeded
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Maximum number of couplings
Definitions: The maximum number of generic couplings in the block has been exceeded.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Reduce the number of generic couplings programmed in the block.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16694 Channel %1 block %2 following axis/spindle %3 status/instruction %4 is
not possible.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Status, instruction
Definitions: The stated instruction is not permitted for the current status of the generic coupling.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16695 Channel %1 block %2 following axis/spindle %3 status/instruction %4 is
not possible.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Status, instruction
Definitions: The stated instruction is not permitted for the current status of the generic coupling.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-292
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006