Siemens SINUMERIK 840Di Diagnostic Manual page 189

11/2006
12701 Channel %1 block %2 illegal interpolation type for contour definition
active
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In one contour definition block, G01 is not active as interpolation function. In one contour definition
block, the linear interpolation always has to be selected with G01. G00, G02, G03, G33 etc. are not
permitted.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program. Program linear interpolation G01.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12710 Channel %1 block %2 illegal language element in external language
mode
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The programmed language element is not allowed or unknown in external language mode. Only the
language elements from Siemens mode which are used for subprogram calls (except for Lxx) and the
language constructs for program repetition with REPEAT (UNTIL) are allowed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Check that the language command is available in Siemens mode. Switch to Siemens mode with G290.
Program the command in the next block and switch back to the external language mode in the
following block.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
12720 Channel %1 block %2 program number for macro call (G65/G66) missing
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During macro call with G65/G66 no program number was defined. The program number must be
programmed with address "P".
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part program.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-189