Siemens SINUMERIK 840Di Diagnostic Manual page 333

11/2006
17130 Channel %1 block %2 analog output no. %3 not activated
Parameters: %1 = Channel number
%2 = Block number, label
%3 = No. of output
Definitions: An attempt has been made by means of the system variable $A_OUTA[n] to write or read an analog
output n that has not been activated by the MD 10310 FASTIO_ANA_NUM_OUTPUTS.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Modify part program or machine data
accordingly.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17140 Channel %1 block %2 NCK output %3 is assigned to a function via
machine data
Parameters: %1 = Channel number
%2 = Block number, label
%3 = No. of output
Definitions: The programmed digital/analog output is assigned to an NC function (e.g. software cams).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Please inform the authorized personnel/service department. Use another output or deactivate
concurrent NC function via MD.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
17150 Channel %1 block %2 maximum of %3 NCK outputs programmable in the
block
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Quantity
Definitions: No more than the specified number of outputs may be programmed in an NC block.
The quantity of hardware outputs is defined in the MDs:
10360 FASTIO_DIG_NUM_OUTPUTS and
10310 FASTIO_ANA_NUM_OUTPUTS
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Program fewer digital/analog outputs in a block. The specified maximum number applies in each case
separately for analog or digital outputs. If necessary, program two NC blocks.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-333