Siemens SINUMERIK 840Di Diagnostic Manual page 293

11/2006
16696 Channel %1 block %2 following axis/spindle %3 coupling has not been
defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: An instruction to an undefined coupling is to be executed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part programm.
Define the coupling and activate, if necessary, before the instruction.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16697 Channel %1 block %2 following axis/spindle %3 coupling has not been
defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
Definitions: An instruction to an undefined coupling is to be executed.
Reaction: NC Start disable in this channel.
Interface signals are set.
Alarm display.
NC Stop on alarm.
Remedy: Modify part programm.
Define the coupling and activate, if necessary, before the instruction.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
16698 Channel %1 block %2 following axis/spindle %3 leading axis/spindle %4
has not been defined.
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Axis name, spindle number
%4 = Axis name, spindle number
Definitions: An instruction to an undefined leading axis/spindle of a coupling is to be executed.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Modify part programm.
Define the leading axis/spindle and activate, if necessary, before the instruction.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-293