Siemens SINUMERIK 840Di Diagnostic Manual page 336

Overview of Alarms
NCK alarms
17188 Channel %1 D number %2 defined in tool T no. %3 and %4
Parameters: %1 = Channel number
%2 = Offset number D
%3 = T number of first tool
%4 = T number of second tool
Definitions: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T numbers %3
and %4 each have an offset with number %2. If tool management is active: The specified T numbers
belong to tool groups with different names.
Reaction: Interface signals are set.
Alarm display.
Remedy: 1. Ensure that the D numbers within the TO unit are unique.
2. If unique numbering is not necessary for subsequent operations, do not use the command.
Program Clear alarm with the Delete key or NC START.
Continuation:
17189 Channel %1 D number %2 of tools defined on magazine/location %3 and
%4
Parameters: %1 = Channel number
%2 = Offset number D
%3 = Magazine/location number of first tool, '/' as separator
%4 = Magazine/location number of second tool, '/' as separator
Definitions: The specified D number %2 in the TO unit of channel %1 is not unique. The specified T numbers %3
and %4 each have an offset with number %2.
If tool management is active:
The specified T numbers belong to tool groups with different names.
Reaction: Interface signals are set.
Alarm display.
Remedy: 1. Ensure that the D numbers within the TO unit are unique, e.g. by renaming the D numbers.
2. If unique numbering is not necessary for subsequent operations, do not use the command.
Program Clear alarm with the Delete key or NC START.
Continuation:
17190 Channel %1 block %2 illegal T number
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: In the displayed block, access is made to a tool that is not defined and therefore not available. The
tool has been named by its T number, its name or its name and duplo number.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
Remedy: Check tool call in the NC part program:
- Correct tool number T.. programmed?
- Tool parameters P1 - P25 defined? The dimensions of the tool edge must have been entered
previously either through the operator panel or through the V.24 interface.
Description of the system variables $P_DP x [n, m]
n ... Associated tool number T
m ... Tool edge number D
x ... Parameter number P
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
2-336
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
11/2006