Siemens SINUMERIK 840Di Diagnostic Manual page 223

11/2006
14162 Channel %1 block %2 error %3 on activation of the CUTMOD function
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Error code
Definitions: An error occurred during the activation of the CUTMOD function. The type of error is more closely
defined by the error code number:
Error code
1No valid cutting direction is defined for the active tool.
2The edge angles (clearance angle and holder angle) of the active tool are both zero.
3The clearance angle of the active tool has an impermissible value (less than 0 degrees or greater
than 180 degrees).
4The holder angle of the active tool has an impermissible value (less than 0 degrees or greater than
90 degrees).
5The cutting tip angle of the active tool has an impermissible value (less than 0 degrees or greater
than 90 degrees).
6
cutting edge positions 1 through 4, the holder angle must be less than or equal to 90 degrees, with
cutting edge positions 5 through 8, it must greater than or equal to 90 degrees).
7
tolerance of about 1 degree) out of the active machining plane. As a result, the cutting edge position
is no longer defined in the machining plane.
With the aid of machine data $MC_CUTMOD_ERR, it can be determined for each of the named errors
whether the fault condition is to lead to the issue of an alarm, and whether the alarm is only to be
displayed or also trigger a program stop.
Reaction: Interpreter stop
Interface signals are set.
Alarm display.
Remedy: Correct the tool data of the active tool, or modify the part program in the case of error 7.
Alternatively, suppress all error alarms with the aid of machine data $MC_CUTMOD_ERR.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
14165 Channel %1 block %2 selected H number %3 does not match tool %4
Parameters: %1 = Channel number
%2 = Block number, label
%3 = H/D number of ISO mode
%4 = Tool number
Definitions: When an H or D number is programmed in ISO_2 mode, it must be available in the active tool. The
active tool may also be the last loaded tool on the master spindle or master toolholder. If there is no
H or D number on this tool, this alarm will be output.
Reaction: Correction block is reorganized.
Local alarm reaction.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Set H number correctly.
Program Clear alarm with NC START or RESET key and continue the program.
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
The cutting edge position - holder angle combination of the active tool is impermissible (with
Impermissible rotation of the active tool (the tool was rotated through +/-90 degrees (with a
Overview of Alarms
NCK alarms
2-223