Siemens SINUMERIK 840Di Diagnostic Manual page 635

11/2006
103004 Block search not possible
Definitions: The search run cannot be started because the channel is active.
Remedy: Wait until the program has been executed or trigger an NC reset.
103005 Block search backwards only possible without calculation
Definitions: --
Remedy: --
103006 Block search without calculation possible on MP level only
Definitions: No subroutine calls can be processed during a block search without calculation.
Remedy: If subroutines are to be processed, a search run with calculation has to be performed.
103007 You cannot terminate overstore in this channel state
Definitions: Overstore cannot be ended because the channel is still active.
Remedy: Wait until the overstore procedure has finished or trigger an NC reset.
103008 Block search started in channel %1 - please wait !
Parameters: %1 = Channel number
Definitions: The started block search is not yet finished.
Remedy: Text is deleted automatically after the end of the block search.
Wait until the block search has finished or trigger an NC reset.
103009 Conflict between search type and search target !
Definitions: The search target entered is not compatible with the search type:
The block number initial character "N" or ":" is missing,
only the digits 0 to 9 are allowed.
Remedy: Correct the entry to correspond with the type.
The following is valid up to SW 3.x: The faulty entry is deleted, and the cursor proceeds to the next
field.
As of SW 4.1: The faulty entry is retained, and the cursor remains at the field.
103010 Invalid file name
Definitions: The file name entered:
Must not have more than 32 characters (letters, digits, underscore; including the block and program
ID:_N_ and _MPF), amounts to 25 assignable characters.
Cannot have any separators (e.g. /).
Must have letters at the first and second position.
Remedy: --
103011 No program selected - block search ended
Definitions: At the moment, no program is selected, therefore, no search run is possible.
Remedy: Select a program.
103012 Safety function not active
Definitions: --
Remedy: --
103013 No agreement could be given
Definitions: --
Remedy: --
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
HMI alarms
2-635