Siemens SINUMERIK 840Di Diagnostic Manual page 147

11/2006
10933 Channel %1 block %2 contour programm does not contain enough
contour blocks
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: The contour program contains:
- Less than 3 contour blocks with CONTPRON
- No contour blocks with CONTDCON
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Increase the size of the subroutine with the stock removal contour to include at least 3 NC blocks with
movements in both axes of the current machining plane.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10934 Channel %1 block %2 array for contour segmentation is set too small
Parameters: %1 = Channel number
%2 = Block number, label
Definitions: During contour segmentation (activated with the keyword CONTPRON), the field for the contour table
has been detected as too small. For every permissible contour element (circle or straight line) there
must be a row in the contour table.
Reaction: Local alarm reaction.
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: Base the definition of the field variables of the contour table on the contour elements to be expected.
The contour segmentation function divides up some NC blocks into as many as 3 machining cuts.
Example: N100 DEF TABNAME_1 [30, 11] Field variables for the contour table provide for 30
machining cuts. The number of columns (11) is a fixed quantity.
Program Clear alarm with the RESET key. Restart part program
Continuation:
10940 Channel %1 block %2 curve table %3: delete/overwrite not possible
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Number of curve table
Definitions: The curve table can only be deleted if it is not active in a link.
Reaction: Interpreter stop
NC Start disable in this channel.
Interface signals are set.
Alarm display.
Remedy: It is necessary to deactivate all links that are being used by the curve table to be deleted.
Program Clear alarm with the RESET key. Restart part program
Continuation:
© Siemens AG, 2006. All rights reserved
SINUMERIK, SIMODRIVE Diagnostics Manual (DA), 11/2006 Edition
Overview of Alarms
NCK alarms
2-147